b21c4b0fa4
The PinePhone Pro uses the same EG25 modem as the OG PinePhone, but with a different SoC. It also uses an ALC5616 audio codec directly hooked up to the modem (which is I2S master in this case). The config is therefore almost identical to the PinePhone rev1.2 except for the gpios, UART port used and `AT+QDAI` config (to account for the different audio setup).
eg25-manager - Quectel EG25 management daemon
eg25-manager is a daemon for managing the Quectel EG25 modem found on the
Pine64 PinePhone.
It implements the following features:
- cleanly power on/off the modem
- configure/check essential parameters (such as the audio format) on startup
- monitor the modem state through ModemManager
- put the modem in low-power mode when suspending the system, and restore it back to normal behavior when resuming
- monitor the modem state on resume and recover it if needed
Dependencies
eg25-manager requires the following development libraries:
- libglib2.0-dev
- libgpiod-dev
- libmm-glib-dev
Building
eg25-manager uses meson as its build system. Building and installing
eg25-manager is as simple as running the following commands:
$ meson ../eg25-build
$ ninja -C ../eg25-build
# ninja -C ../eg25-build install
Configuration
eg25-manager uses device-specific configuration files, named after the
device-tree compatible field. These files are installed to
/usr/share/eg25-manager. They can be copied to /etc/eg25-manager then
modified, that way they won't be overwritten during an upgrade.
Running
eg25-manager is usually run as a systemd service, but can also be
manually started from the command-line (requires root privileges):
# eg25manager
License
eg25-manager is licensed under the GPLv3+.