mirror of
https://xff.cz/git/u-boot/
synced 2025-10-31 18:35:42 +01:00
e7005b3e80
Communication with some SPI slaves just won't cut it if these delays (before the beginning, and after the end of a transfer) are not added to the Chip Select signal. These are a straight copy from Linux: Documentation/devicetree/bindings/spi/spi-fsl-dspi.txt drivers/spi/spi-fsl-dspi.c Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com> [Rebased] Signed-off-by: Priyanka Jain <priyanka.jain@nxp.com>
35 lines
1.2 KiB
Plaintext
35 lines
1.2 KiB
Plaintext
Freescale ColdFire DSPI controller
|
|
|
|
Required properties:
|
|
- compatible : "fsl,mcf-dspi"
|
|
- #address-cells: <1>, as required by generic SPI binding
|
|
- #size-cells: <0>, also as required by generic SPI binding
|
|
- reg : offset and length of the register set for the device
|
|
|
|
Optional properties:
|
|
- spi-max-frequency : max supported spi frequency
|
|
- num-cs : the number of the chipselect signals
|
|
- spi-mode: spi motorola mode, 0 to 3
|
|
- ctar-params: CTAR0 to 7 register configuration, as an array
|
|
of 8 integer fields for each register, where each register
|
|
is defined as: <fmsz, pcssck, pasc, pdt, cssck, asc, dt, br>.
|
|
- fsl,spi-cs-sck-delay: a delay in nanoseconds between activating chip
|
|
select and the start of clock signal, at the start of a transfer.
|
|
- fsl,spi-sck-cs-delay: a delay in nanoseconds between stopping the clock
|
|
signal and deactivating chip select, at the end of a transfer.
|
|
|
|
Example:
|
|
|
|
dspi0: dspi@fc05c000 {
|
|
compatible = "fsl,mcf-dspi";
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
reg = <0xfc05c000 0x100>;
|
|
spi-max-frequency = <50000000>;
|
|
num-cs = <4>;
|
|
spi-mode = <0>;
|
|
ctar-fields = <7, 0, 0, 0, 0, 0, 1, 6>,
|
|
<7, 0, 0, 0, 0, 0, 1, 6>,
|
|
<7, 0, 0, 0, 0, 0, 1, 6>;
|
|
};
|