mirror of
https://xff.cz/git/u-boot/
synced 2026-01-08 17:29:17 +01:00
6cf1cc987f
ft_board_setup relies on the board_type() function to optimize which phy
nodes need to be enabled for Linux.
Add calls to setup and release the board-detect GPIOs.
Also fix the switch-case statement to only enable phy address 4 for
Cubox and unknown devices.
Fixes: 741ce308 ("mx6cuboxi: fixup dtb ethernet phy nodes before booting an OS")
Signed-off-by: Josua Mayer <josua@solid-run.com>
How to use U-Boot on Solid-run mx6 Hummingboard and Cubox-i ----------------------------------------------------------- - Build U-Boot for Hummingboard/Cubox-i: $ make mrproper $ make mx6cuboxi_defconfig $ make This will generate the SPL image called SPL and the u-boot.img. - Flash the SPL image into the SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot.img image into the SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card in the board, power it up and U-Boot messages should come up.