Add a 100ms delay before PWRKEY sequence

This brings the power on sequence in line with the EG25-G Hardware Design
datasheet, which states we need to wait at least 30 ms after VBAT becomes stable
before pulling PWRKEY low (first action of the power on sequene).

After this change the sequence becomes as follows:
- Set RESET_N high
- Wait 60 ms (double 30 ms)
- Execute PWRKEY sequence

60 ms was choosen because we don't know when VBAT becomes stable, but it should
be much less than an additional 30 ms. Empirical evidence suggests PinePhone
units with a healthy battery do not see serious side effects from not doing
this, while the modem will fail to boot and/or throw random errors on boot with
a worn out battery.

data/pine64,pinephone-1.0.toml

@@ -3,6 +3,9 @@ need_libusb = true
 usb_vid = 0x2c7c
 usb_pid = 0x0125
 
+# Delay between setting GPIO and PWRKEY sequence, set in microseconds
+poweron_delay = 100000
+
 # Uncomment the following if you need to change the modem detection timeout on
 # resume and/or the time during which suspend is blocked after modem boot
 #[suspend]